Satus 3 EFI Kit

Introducing Satus 3, your entry into the world of high performance, ideal for those who are new to this exciting passion. Designed with ease of use in mind without compromising the power you're looking for, get ready to take your riding experience to the next level!

Engines and supported modes:

Full Sequential (Fuel & Ignition):
Up to 4 cylinders.

Semi Sequential (Fuel & Ignition):
Up to 8 cylinders.

Supported Trigger Patterns:

Inputs:

Integrated 4 BAR MAP sensor
Integrated barometric sensor
2 x Knock Sensor
Micro SD Card Slot (Data Logger)
Coolant temperature sensor
Intake air temprature sensor
Throttle position sensor
CKP / CMP (integrated smart signal conditioner, max9926 based. Hall, VR, and optical sensors are supported)
Vehicle Speed Sensor (Hall type)
O2 Sensor
Clutch Switch
Table Switch
Flex Fuel sensor
External MAP.
Notes:
The inputs can be reconfigured for another purpose, this list shows the default configuration.
The external MAP and VSS inputs share the same pin, this input is configured by a jumper.
The table switch and Flex Fuel inputs share the same pin, this input is configured by a jumper.

Outputs:

4 x fuel injector outputs (Only high impedance injectors are supported)
4 x ignition outputs. (5v signal for driving logic level coils or modules)
CAN Bus
Stepper IAC
Fuel Pump Relay
Tachometer output (Only low voltage tachometers are supported)
5v for sensors
4 x General purpose High Current outputs (12A)
Notas:
The General purpose outputs can be used to control: VVT / Boost / Nitrous / PWM IAC Solenoids, Fan Control, Generic PWM, Alternator.
Unused injector outputs can be reassigned to another function.

Technical specifications:
Processor: Freescale S12XE High-Performance Automotive Microcontroller
Tuning Software: EFI Analytics TunerStudio
Communication: USB-B and Bluetooth Classic
Input voltage: 6v to 24v
Dimensions (ECU): 3X12X10CM
Wight: 180g
Housing material: PET

Firmware Features:

Speed density / Alpha-N / ITB fueling algorithms
Fuel and Spark can be configured to use different algorithms
Intelligent Knock Detection and Response – 1 channel
Data logging to MicroSD memory
16×16 maps
Dual map support / Table Switch
Launch control: 2 Step, 3 Step, T-Brake
Flat Shift
Boost control: open loop and closed loop modes
Over Boost protection
Idle control: open loop, closed loop, and ON/OFF
Water / Meth Injection
Traction Control
Sequential fuel trim
Support for odd fire / even fire / rotary engines
Realtime barometric correction
Programmable outputs conditioned by up to 2 parameters
Acceleration enrichment: TPS and MAP based
AFR Correction: Simple and PID
Engine protection
Staged Injection
Pit Lane Limiter
Three-step rev limiter with flat shift
Overdwell protection
Cooling fan control (ON / OFF, PWM)
PWM Fuel Pump / Pressure control (External SSR required)
Nitrous: 1 Stage / 2 Stage
VSS and gear detection
VVT: Open loop, Closed loop, ON/OFF
Configurable tach output
Sensor Calibration
Sensor Checking with Check Engine Light Support
Support for Drive by Wire external modules
Alternator Field Control / Voltage Regulation (External SSR required)
CAN: I/O expansion, CAN Broadcast, Multiple dash and some OEM clusters are supported
Autotune (Requires the registered version of TunerStudioMS)